Contract Finish Trim Check shop for materials Need materials to connect water heater. 7:00am Time and Materials Have to add a RG6 coax run. James knows the route it needs to take and where it goes.

Contract Pull feeders Make sure ready for pre-power inspection 7:00am

Contract Materials in shop on pallet Service change scheduled for 8:00am Need feeder measurements to new panel Trim out complete Connect a/c equipment 7:00am

Contract Materials in shop Inspection scheduled Need wire measurement for addition panel. SECO disconnecting at 9:00am 7:00am job site

SEE NOTE BELOW*** Time and Materials Breaker in shop Install quad breaker and connect power to GFI at service for construction. 8-9:00am ***this is a construction site where we’re actively doing a remodel and this breaker can be installed at any time on the way back from J concepts we could knock this out enroute…

Contract 7:00am

Contract EMT on front apron, may be other materials in shop on pallet or outgoing job shelf 7:00am

Contract (After Aronoff)

Contract Materials in shop Make sure you get book and print from office 11:00am

Contract Heat conduit up and roll into wall Frame wall will be flush with block on stairwell side. (After you get the guys going at 156) talk with me and Ben about this. He may have time to catch this after he gets done at Rosemary Gay’s